You have commented 375 times on Rantburg.

Your Name
Your e-mail (optional)
Website (optional)
My Original Nic        Pic-a-Nic        Sorry. Comments have been closed on this article.
Bold Italic Underline Strike Bullet Blockquote Small Big Link Squish Foto Photo
-Short Attention Span Theater-
Today's Idiots
2007-05-30
Men in trouble for driving on Pierce County airport runway

GIG HARBOR, Wash. - Two men are in hot water after taking a joyride on the runway of a Pierce County airport Saturday night. Police say it appears the two, in their early 20s, had been drinking as they jumped in the car and took it for a spin in a place they shouldn't have.

Both are believed to be employees of the Tacoma Narrows Airport, so they had the authorization to be there, but that privilege was abused. "One or both occupants of the car already had access to the airport, so this is in no way tied to terrorist activity or breach of homeland security," said Corey Darlington of the Tacoma Police Dept.

But doing what they did could cost them their jobs. A security guard at the airport says the Pontiac Grand Am must have been going at least 100 miles an hour down the runway. "They drove their car to the south end of the runway. They then drove their car to the north end at an extremely high rate of speed," said Darlington.
"Hoooooo-wheeeeeeee!"
That's when something went wrong and the driver lost control. The car went flying off the tarmac, through a field for roughly 100 yards, then flew about 60 feet in the air, slammed into the side of a hill, and rolled to the bottom. The passenger suffered a fractured leg. The driver had some bumps and bruises.

Police say the driver most likely will face some type of criminal charge for being out on the runway, and the FAA could step in and investigate.
Posted by:Thaque Slugum2296

#9  comments); ?>werwer
Posted by: mojo   2007-05-30 16:24  

#8  comments); ?>werwer
Posted by: Anguper Hupomosing9418   2007-05-30 15:06  

#7  comments); ?>werwer
Posted by: RD   2007-05-30 15:01  

#6  comments); ?>werwer
Posted by: Alaska Paul   2007-05-30 11:24  

#5  comments); ?>werwer
Posted by: Mark E.   2007-05-30 10:20  

#4  comments); ?>werwer
Posted by: Mark E.   2007-05-30 10:15  

#3  comments); ?>werwer
Posted by: Mike   2007-05-30 06:29  

#2  comments); ?>werwer
Posted by: Zenster   2007-05-30 03:46  

#1  comments); ?>werwer
Posted by: gorb   2007-05-30 02:46  

00:00